I don't know. But if you look at the datasheet it doesn't say anything about sFlow. Foundry pushes sFlow pretty hard and it is prominent on the datasheets for other products. So I doubt it.
C -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Tim Holmes Sent: Wednesday, October 13, 2004 2:36 PM To: [EMAIL PROTECTED] Subject: RE: [Ntop] Question (probably dumb) from a new user Chris: Do you know if S flow can be enabled on our edge irons as well? Tim�Holmes � IT Manager Medina Christian Academy, Inc. A Higher Standard... � Jeremiah 33:3 Jeremiah 29:11 Esther 4:14 ********************************************************************** Confidential/Proprietary Note The information in this email is confidential and may be legally privileged. Access to this email by anyone other than the intended addressee is unauthorized. If you are not the intended recipient of this message, any review, disclosure, copying, distribution, retention, or any action taken or omitted to be taken in reliance on it is prohibited and may be unlawful. If you are not the intended recipient, please reply to or forward a copy of this message to the sender and delete the message, any attachments, and any copies thereof from your system. Thank you. Guardian Mortgage Documents, Inc. 225 Union Boulevard, Suite 200 Lakewood, CO 80228. ********************************************************************** _______________________________________________ Ntop mailing list [EMAIL PROTECTED] http://listgateway.unipi.it/mailman/listinfo/ntop
