This really isn't an ntop question ... It belongs with the switch vendor.
Because it's dependent on their implementation of sFlow and (more
importantly) on what 'chain-linked' is and how it's implemented.

Within the realm of standard Ethernet and tcp/ip, the 'procurve' switch in
your diagram will never see packets local to either of the 'non-sFlow'
switches, so it wouldn't be able to report ANYTHING about them.

-----Burton

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of
Victor Rodriguez Cortes
Sent: Tuesday, May 16, 2006 10:21 AM
To: [EMAIL PROTECTED]
Subject: [Ntop] SFlow and chain linked switches

        Hello,

        I'm new to the list and maybe someone has some experience with this
and could give me some advice. I sent this questions to the Misc list, but I
didn't received any reply yet. I hope that someone here may help me.

        I would like to know what kind of information would SFlow give me
from a chain- linked switch that does NOT support SFlow. The network would
be something like this (sorry, I'm too bad drawing with letters!):


                     Gateway
                        |
                Procurve 2800
                 |       |
Non-sflow switchA       Non-slow switchB
        |                       |
Network devices Network devices


        For some systems (printers, voip phones, some departments...) I do
not need the 
performance of one Procurve's Gb port, so I would use those ports for other
systems and use 
a different switch to give network access to less performance-hungry
devices. It's basically a 
matter of cost per port, trying to avoid buying 2 or more ProCurve and reuse
some basic 
switches that I have right now.

        - Would I see real information for traffic that comes from / goes to
systems 
connected 
to the Non-sflow switches? Obviously all traffic would be detected on the
Procurve port that 
has switchA and switchB connected to, but I suppose that I should get the IP
address of each 
system and be able of identify each one through it (as is there was just one
system with many 
IP addresses).

        - Would I be able of getting real traffic stats from those systems?

        - Would all this work if the switches are connected with a 2Gb
trunk?

        Many thanks in advance,
        Victor.



_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop

_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop

Reply via email to