Hi all,
I have a site where the original wifi/router (cisco RV 120 w) was replaced due
to the inability to establish a VPN. We now have a new router in place and it
is working fine, however, the new router doesn't have a wifi, so my intent was
to just plug in the on the lan so they can have wifi.
Here is the setup
ISP> WAN port on New VPN router (ip 10.0.4.1) > LAN port on Cisco wifi >
Cisco set to 10.0.4.200, dhcp server enabled , range 10.0.4.201-10.0.4.220,
The issue I'm facing is that I do not have the ability to specify the default
gateway on Cisco (at least I cant see it in the GUI) , as a result when client
connects to the wifi it gets an IP of 10.0.4.221 but the gateway it gets is
the IP of the cisco (10.0.4.200) as a result they have no internet access.
And to add insult to injury , this is in the remote office with the worst
connection (256k sat)
So trouble shooting has been miserable to say the least-
The only upside is that the laptop I'm remoting into has a 3/4g USB key , so it
isn't as painful, however the per mb charge is going through the roof.
I have this same setup in another office, with the exception that linksys
router (providing wifi) has dd-wrt and I am able to specify the gateway.
