This is not an AP, right? It's actually a router/fw? I would put an AP in there if at all possible.
On Thu, Jul 3, 2014 at 10:54 AM, J- P <[email protected]> wrote: > I have 3 options on the AP > DHCP > DHCP RELAY > NONE > > should I go relay, and set the Remote DHCP server , > > Or just disable it all together? > > > Jean-Paul Natola > > > > ------------------------------ > From: [email protected] > To: [email protected] > Subject: Re: [NTSysADM] Router as AP > Date: Thu, 3 Jul 2014 14:14:48 +0000 > > Serve DHCP on the new VPN router and not the WiFi AP. The AP will just > bridge wireless to wired. > > > On Jul 3, 2014, at 10:02 AM, J- P <[email protected]> wrote: > > Hi all, > > I have a site where the original wifi/router (cisco RV 120 w) was replaced > due to the inability to establish a VPN. We now have a new router in place > and it is working fine, however, the new router doesn't have a wifi, so my > intent was to just plug in the on the lan so they can have wifi. > > Here is the setup > > ISP> WAN port on New VPN router (ip 10.0.4.1) > LAN port on Cisco wifi > > > Cisco set to 10.0.4.200, dhcp server enabled , range 10.0.4.201-10.0.4.220, > > The issue I'm facing is that I do not have the ability to specify the > default gateway on Cisco (at least I cant see it in the GUI) , as a result > when client connects to the wifi it gets an IP of 10.0.4.221 but the > gateway it gets is the IP of the cisco (10.0.4.200) as a result they have > no internet access. > > And to add insult to injury , this is in the remote office with the worst > connection (256k sat) > So trouble shooting has been miserable to say the least- > > The only upside is that the laptop I'm remoting into has a 3/4g USB key , > so it isn't as painful, however the per mb charge is going through the roof. > > I have this same setup in another office, with the exception that linksys > router (providing wifi) has dd-wrt and I am able to specify the gateway. > > > >
