Hi Carlos It appears to succeed. >From syslog May 12 06:17:51 test1 upsd[12154]: Connection from 127.0.1.1 May 12 06:17:51 test1 upsd[12154]: Instant command: [EMAIL PROTECTED] did beeper.toggle on ups1 May 12 06:17:51 test1 upsd[12154]: Client [EMAIL PROTECTED] logged out May 12 06:17:51 test1 megatec[12152]: Toggling UPS beeper. May 12 06:18:59 test1 megatec[12152]: Communications with UPS lost: No status from UPS. May 12 06:19:01 test1 megatec[12152]: Communications with UPS re-established May 12 06:19:15 test1 upsd[12154]: Connection from 127.0.1.1 May 12 06:19:15 test1 upsd[12154]: Client on 127.0.1.1 logged out May 12 06:20:23 test1 megatec[12152]: Communications with UPS lost: No status from UPS. May 12 06:20:25 test1 megatec[12152]: Communications with UPS re-established May 12 06:25:05 bitt1 megatec[12152]: Communications with UPS lost: No status from UPS. May 12 06:25:07 bitt1 megatec[12152]: Communications with UPS re-established May 12 06:26:01 bitt1 upsd[12154]: Connection from 127.0.1.1 May 12 06:26:10 bitt1 upsd[12154]: Instant command: [EMAIL PROTECTED] did beeper.toggle on ups1 May 12 06:26:10 bitt1 upsd[12154]: Client [EMAIL PROTECTED] logged out May 12 06:26:10 bitt1 megatec[12152]: Toggling UPS beeper.
But upsc shows, ups.beeper.status: disabled after each toggle command I've tried this via the cgi interface and upscmd. Regards, Peter On Thu, 2008-05-08 at 09:46 +0100, Carlos Rodrigues wrote: > On Thu, May 8, 2008 at 4:20 AM, Peter McKenna <[EMAIL PROTECTED]> wrote: > > That's correct. I used to be able to toggle it in Nut 2.0 and > > the response from upsc would show off/on, but if you unplugged it it would > > still beep. I assumed there where other less critical beep alerts being > > turned off. > > Then it never actually worked, it only appeared to work. The driver > was probably assuming the beeper was on at startup and just changing > its internal state when you issued the toggle command without actually > getting that state from the UPS. > > Can you check the logs (/var/log/messages or similar, depending on the > distribution you're using) to see if there's any message there > indicating the beeper.toggle command didn't succeed? >
_______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
