Nate,
thanks,
Gotta slide under the beauty and take a look/clean the FW, etc, will keep you
informed,,,
Warren
vwnate1 <[EMAIL PROTECTED]> wrote:
The dynamic timing mark will be clear as a bell as it is a hole with
a steel BB jammed into it .
The TDC mark may be very faintly stamped , it will be either a
triangle (most common) or a chevron , I find it helpful to remove the
clutch scatter pan and rotate the engine with a leather glove (those
ring gear teeth are palm killers) untill I see the triangle and BB ,
I clean them up with a wire brush and then I use a white or yellow
lumber crayon to draw a circle 'round the BB and I work some crayon
into the triangle so it's easily visable through the timing window
above the starter motor .
Remove the spark plugs before you begin so the engine rotates easily .
Set the triangle to the timing pointer as the # 1 cylinder intake
valve has just closed and ensure the tip of the distributor rotor is
pointing at 6:00 ~ this is 90° dead away from the engine . make sure
when you re-install the dizzy that the oil pump tang has aligned else
you'll not get any oil pressure...
Engine all positioned ? good ~ now connect youe test light to the
points side of the ignition coil and ground it well (carby is always
my choice) and turn on the key , loosen the dizzy pinch clamp screw a
little bit and push the dizzy _counter_clockwise_ untill the test
light just goes out . if you have an uncut vacuum advance line , the
timing will want to drift so pay close attention .
Tighten the pinch clamp and re-install the spark plugs , ensure the
plug wires are in the correct order of : 1 , 5 , 3 , 6 , 2 , 4 . the
# 1 cylinder plug wire goes , naturally in line with the dizzy cap
nipple that lines up with the tip of the rotor .
This should get your engine started , remember to check and re-adjust
the valves as necessary once the engine gets fully warmed up .
I hope this helps....
-Nate
Warren wrote:
>
> ....Found the
procedure in the shop manual. One last question, how promenent are
the marking on the fly wheel. I did find the pointer in the hole near
the starter
>
> Warren
[Non-text portions of this message have been removed]
Ole Chevy and GMC trucks rule!
To unsubscribe, send an email (with no subject, no body, just the email), to:
[EMAIL PROTECTED]
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/old-chevy-truck/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/old-chevy-truck/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:[EMAIL PROTECTED]
mailto:[EMAIL PROTECTED]
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
