Yes, but the problem is that with ifconfig the changes are not persistent.
2014/1/22 Zach Malone <[email protected]>: > I bet the old ifconfig mtu commands will work, even if dladm won't > modify the interface. > > On Wed, Jan 22, 2014 at 11:09 AM, David Seira <[email protected]> wrote: >> Hi all, >> >> I'm trying to figure out how change the mtu of a vlan interface once >> it is created. >> >> First I've created the aggr interface with the mtu 1500. Then I've >> created a vlan for this interface with the same mtu. >> >> Next I want to change the mtu of this connection. First I've changed >> the mtu of the aggr: >> >> #dladm set-linkprop -p mtu=9000 aggr0 >> >> But the problem comes when I've tried to change the mtu of the vlan >> interface with the same command; I receive the next message: >> >> dladm: warning: cannot set link property 'mtu' on 'aggr0.164': >> operation not supported >> >> I've also tried disable the interface but with the same result. >> >> If I delete and create the vlan interface again (with the aggr0 with >> the mtu 9000) it works. >> >> I don't understand why is not possible to change the mtu of a vlan >> interface once it is created. >> >> Is possible? How can I do that? >> >> >> Regards, >> David >> _______________________________________________ >> OmniOS-discuss mailing list >> [email protected] >> http://lists.omniti.com/mailman/listinfo/omnios-discuss > _______________________________________________ > OmniOS-discuss mailing list > [email protected] > http://lists.omniti.com/mailman/listinfo/omnios-discuss _______________________________________________ OmniOS-discuss mailing list [email protected] http://lists.omniti.com/mailman/listinfo/omnios-discuss
