Hi Karanbir,
thanx for your fast answer.
I've tried loading the sk98lin module by hand, it loads ok but
/proc/net/sk98lin is empty and ifconfig eth0 up says that there is not
eth0. So I suppose that my card is not supported by that module.
As I was not able to get the network running, it's a bit difficulty to
get those lspci outputs to you. I've written down the following, which
might be helpful:
lspci -v:
02:00.0 <blabla> Marvell Gigabit Ethernet Controller (88E8053) <blabla>
(rev19)
03:00.0 - same -
lspci -n:
02:00.0 Class 0200: 11ab:4362 (rev19)
03:00.0 Class 0200: 11ab:4362 (rev19)
Hope it helps. Btw. it's an AOpen mainboard with ICH6 chipset.
Regards,
Frank
-----Original Message-----
Date: Wed, 24 May 2006 22:36:49 +0200
Subject: Re: [OF-users] Using 2.0 beta 1 with Marvell GBit NIC?
From: Karanbir Singh
To: Frank Trietsch
Frank Trietsch wrote:
> Hi,
>
> I'm trying to get openfiler running on a mobo containig two Marvell
GBit
> chips onboard. Seems that the kernel modules are not available in the
> standard distribution.
> Has anybody an idea which kernel module is needed for the Marvell
chip?
> Is there any other chance to get that thing running (besides using
> another NIC)?
>
The sk98lin module should work for the Marvel GB interface... can you
post an output of lspci -v and lspci -n ?
- KB
--
Karanbir Singh : http://www.karan.org/ : [EMAIL PROTECTED]
_______________________________________________
Openfiler-users mailing list
[email protected]
https://lists.openfiler.com/mailman/listinfo/openfiler-users
_______________________________________________
Openfiler-users mailing list
[email protected]
https://lists.openfiler.com/mailman/listinfo/openfiler-users
