Frank Trietsch wrote: > Hi Karanbir, > > thanx for your fast answer. > I've tried loading the sk98lin module by hand, it loads ok but > /proc/net/sk98lin is empty and ifconfig eth0 up says that there is not > eth0. So I suppose that my card is not supported by that module. > As I was not able to get the network running, it's a bit difficulty to > get those lspci outputs to you. I've written down the following, which > might be helpful: > > lspci -v: > 02:00.0 <blabla> Marvell Gigabit Ethernet Controller (88E8053) <blabla> > (rev19) > 03:00.0 - same - > > lspci -n: > 02:00.0 Class 0200: 11ab:4362 (rev19) > 03:00.0 Class 0200: 11ab:4362 (rev19) > > Hope it helps. Btw. it's an AOpen mainboard with ICH6 chipset. > > Regards, > > Frank > > -----Original Message----- > Date: Wed, 24 May 2006 22:36:49 +0200 > Subject: Re: [OF-users] Using 2.0 beta 1 with Marvell GBit NIC? > From: Karanbir Singh > To: Frank Trietsch > > Frank Trietsch wrote: >> Hi, >> >> I'm trying to get openfiler running on a mobo containig two Marvell > GBit >> chips onboard. Seems that the kernel modules are not available in the >> standard distribution. >> Has anybody an idea which kernel module is needed for the Marvell > chip? >> Is there any other chance to get that thing running (besides using >> another NIC)? >> > > The sk98lin module should work for the Marvel GB interface... can you > post an output of lspci -v and lspci -n ? > > - KB
The interface I seem to have is an 88E8001 and a 88E8002 and they both work fine with the sk98lin module from the latest kernel.... you might need an updated driver, I am back at work on Friday, will poke and see if I can dig up something for you. also, try not to top post - it really makes it hard to track the conversation and in most cases, you'll find people ignore such top posted messages on a mailing list. - KB -- Karanbir Singh : http://www.karan.org/ : [EMAIL PROTECTED] _______________________________________________ Openfiler-users mailing list [email protected] https://lists.openfiler.com/mailman/listinfo/openfiler-users
