> Date: Thu, 25 Apr 2013 16:40:47 +0200
> From: [email protected]
> To: [email protected]
> Subject: Re: [OpenIndiana-discuss] link property e1000 / igb
>
> On 2013-04-25 13:59, Randy S wrote:
> > Hi all,
> >
> > version OI5a7
> >
> > I'm trying to force a nic to work at 1000 mb.
> > To
> > test the commands first, I usually test it on a testsystem. I
> > found some docs from oracle stating that if you want to force a nic to
> > perform at a certain speed, you should disable advertising the speeds
> > that you don't want with the command: dladm set-linkprop -p adv
> > adv_100fdx_cap=0 e1000g0
> > and
> > dladm set-linkprop -p adv_100hdx_cap=0 e1000g0
>
> What device is the link partner on other side of the cable?
> Does it support (or limit) negotiation of speeds?
>
> I am not sure why the "read-only" problem, but as long as negotiation
> is enabled on both sides, the devices should connect on best speeds
> available to them (and supported by cable, i.e. 1000Mbps needs all
> eight wires in UTP working properly and laid out in correct order).
>
> Note also that if one side has duplex-negotiation disabled, while
> another has it enabled, the active side won't see responses to its
> negotiation queries and should fall back to half-duplex. If you've
> forced full-duplex on the inactive side, there can be problems.
> I am not sure if speed negotiation works similarly, may depend...
> However, for 1000Mbps I haven't seen use or implementations of HDX,
> though discussed in the standard. Might be that the default is FDX
> in higher speeds.
>
> HTH,
> //Jim
>
>
> _______________________________________________
> OpenIndiana-discuss mailing list
> [email protected]
> http://openindiana.org/mailman/listinfo/openindiana-discuss
Hi Jim,
As usual, you are willing to lend a helping hand. I thank you for that !
I looked at the output of "dladm show-linkprop igb0" and decided to just change
the property which has the rw attribute. And yes, this works. So there seems to
be a diff between what works in solaris and what works in OI in this regard.
So the properties that can be changed seem to be:
en_1000fdx_cap
en_100fdx_cap
en_100hdx_cap
and so forth.
I assume that these settings are persistent across reboots (well I'll just test
it).
If I'm doing anything wrong I hope to be corrected in time.
To clarify why I'm testing this:
we have a machine in production with a nic (autonegotiation) that should be
1000Mb connected but is 100Mb connected. We already forced the switchport at
1000Mb at which point there is no connection with the OI machine. It's an
onboard nic . If I cannot force the Oi nic to go 1000Mb, I guess the nic is
broken... The same switch port has been tested with another machine which does
connect at 1000Mb, so the switch is ok.
Rgds,
R
_______________________________________________
OpenIndiana-discuss mailing list
[email protected]
http://openindiana.org/mailman/listinfo/openindiana-discuss
