On 11/5/25 4:54 AM, Bagas Sanjaya wrote:
> Steps for loading IPMB driver at boot time, written as enumerated
> sublist, is indented instead on the same level as its parent list.
> Indent them as appropriate.
>
> Signed-off-by: Bagas Sanjaya <[email protected]>
LGTM. Thanks.
Acked-by: Randy Dunlap <[email protected]>
Tested-by: Randy Dunlap <[email protected]>
> ---
> Documentation/driver-api/ipmb.rst | 48 +++++++++++++++----------------
> 1 file changed, 24 insertions(+), 24 deletions(-)
>
> diff --git a/Documentation/driver-api/ipmb.rst
> b/Documentation/driver-api/ipmb.rst
> index 209c49e051163f..dd99d034272b7e 100644
> --- a/Documentation/driver-api/ipmb.rst
> +++ b/Documentation/driver-api/ipmb.rst
> @@ -48,35 +48,35 @@ CONFIG_IPMB_DEVICE_INTERFACE=y
>
> 1) If you want the driver to be loaded at boot time:
>
> -a) Add this entry to your ACPI table, under the appropriate SMBus::
> + a) Add this entry to your ACPI table, under the appropriate SMBus::
>
> - Device (SMB0) // Example SMBus host controller
> - {
> - Name (_HID, "<Vendor-Specific HID>") // Vendor-Specific HID
> - Name (_UID, 0) // Unique ID of particular host controller
> - :
> - :
> - Device (IPMB)
> - {
> - Name (_HID, "IPMB0001") // IPMB device interface
> - Name (_UID, 0) // Unique device identifier
> - }
> - }
> + Device (SMB0) // Example SMBus host controller
> + {
> + Name (_HID, "<Vendor-Specific HID>") // Vendor-Specific HID
> + Name (_UID, 0) // Unique ID of particular host controller
> + :
> + :
> + Device (IPMB)
> + {
> + Name (_HID, "IPMB0001") // IPMB device interface
> + Name (_UID, 0) // Unique device identifier
> + }
> + }
>
> -b) Example for device tree::
> + b) Example for device tree::
>
> - &i2c2 {
> - status = "okay";
> + &i2c2 {
> + status = "okay";
>
> - ipmb@10 {
> - compatible = "ipmb-dev";
> - reg = <0x10>;
> - i2c-protocol;
> - };
> - };
> + ipmb@10 {
> + compatible = "ipmb-dev";
> + reg = <0x10>;
> + i2c-protocol;
> + };
> + };
>
> -If xmit of data to be done using raw i2c block vs smbus
> -then "i2c-protocol" needs to be defined as above.
> + If xmit of data to be done using raw i2c block vs smbus
> + then "i2c-protocol" needs to be defined as above.
>
> 2) Manually from Linux::
>
>
> base-commit: 27600b51fbc8b9a4eba18c8d88d7edb146605f3f
--
~Randy
_______________________________________________
Openipmi-developer mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openipmi-developer
