2009/4/6 OMAP3 <[email protected]>: > So, I used ar6k driver for firmware 1.3, applied your patches for Linux SDIO, > and had to adapt a few things, but not that much. Nevertheless, the card > still doesn't answer while init : > mmc0: new SDIO card at address 0001 > eth0: link down > ar6000_available > BMI Get Target ID: Enter (device: 0xc048dac8) > BMI Communication timeout > Unable to write to the device >
It seems you got the same issue as i got. The driver failed to read the Target info of card. I still have no ideas on why that. But something strange is that from the log in your first mail, it looks you already successfully got it as follows: "BMI Get Target Info: Exit (ver: 0x1301000e type: 0x1) Block Size Set: 128 (target " But the driver can not get it now. Is there any big difference between the two version of code or HW? Regards Dongas
