Hi all
dongas wrote:
2009/4/6 OMAP3 <[email protected]>:
So, I used ar6k driver for firmware 1.3, applied your patches for Linux SDIO,
and had to adapt a few things, but not that much. Nevertheless, the card still
doesn't answer while init :
mmc0: new SDIO card at address 0001
eth0: link down
ar6000_available
BMI Get Target ID: Enter (device: 0xc048dac8)
BMI Communication timeout
Unable to write to the device
It seems you got the same issue as i got. The driver failed to read
the Target info of card.
I still have no ideas on why that.
But something strange is that from the log in your first mail, it
looks you already successfully got it as follows:
"BMI Get Target Info: Exit (ver: 0x1301000e type: 0x1) Block Size Set:
128 (target "
But the driver can not get it now.
Is there any big difference between the two version of code or HW?
Regards
Dongas
Anyone has the datasheet, maybe the offset address are different.
Michael
