Hi,
I am facing the issue below when using the ftdi/flyswatter.cfg file
interface:
>>>>
Open On-Chip Debugger 0.7.0 (2013-05-05-22:01)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.sourceforge.net/doc/doxygen/bugs.html
WARNING!
This file was not tested with real interface, it is based on schematics and
code
in ft2232.c. Please report your experience with this file to openocd-devel
mailing list, so it could be marked as working or fixed.
Info : only one transport option; autoselect 'jtag'
RCLK - adaptive
fast memory access is enabled
dcc downloads are enabled
force hard breakpoints
use of EmbeddedICE dbgrq instead of breakpoint for target halt enabled
trst_and_srst separate srst_gates_jtag trst_push_pull srst_open_drain
connect_deassert_srst
Info : RCLK (adaptive clock speed) not supported - fallback to 1500 kHz
Error: JTAG scan chain interrogation failed: all ones
Error: Check JTAG interface, timings, target power, etc.
Error: Trying to use configured scan chain anyway...
Error: omapl138.jrc: IR capture error; saw 0x3f not 0x01
Warn : Bypassing JTAG setup events due to errors
Error: Target not examined yet
...
<<<<
Here you can find the schematic for details:
https://www.tincantools.com/assets/FLYSWATTER_REV-B.pdf
Many thanks,
Laszlo
------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:
Build for Windows Store.
http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
