On Thu, May 08, 2014 at 10:34:20AM -0700, Tim Wescott wrote: > Based on some comments in the release notes about flash support for the > LPC800 and LPC810, I was hoping that these chips would also be supported > for debugging.
They were supported for debugging since long (basically, since stlink support was introduced). > I just finished building and installing OpenOCD 0.8.0, hoping that there > would be a target file for the LPC81x. > > To my disappointment, I didn't see any. Yes, the proper target config structure for the numerous LPC parts is WiP, but for the time being you can quickly hack something based on some existing lpc config (using lpc2000 driver), just set lpc800 variant there and appropriate working area size (less than or equal to RAM of your chip). > How much support is there for this chip? Might it be possible for me to > cobble together a configuration file for the LPC811M00 as a target? Should be fairly easy, yes. HTH -- Be free, use free (http://www.gnu.org/philosophy/free-sw.html) software! mailto:[email protected] ------------------------------------------------------------------------------ Is your legacy SCM system holding you back? Join Perforce May 7 to find out: • 3 signs your SCM is hindering your productivity • Requirements for releasing software faster • Expert tips and advice for migrating your SCM now http://p.sf.net/sfu/perforce _______________________________________________ OpenOCD-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/openocd-devel
