Hi!
OpenOCD doesn't have an official forum. For general help, use the user mailing
list: https://lists.sourceforge.net/mailman/listinfo/openocd-user
I guess you've found it out by now that OpenOCD looks for config files in the
current directory. Plus under the user's home directory, some shared paths,
etc. But openocd.cfg is generally best suited for project specific settings in
the project directory. Running openocd from that directory gives the desired
result.
---
** [tickets:#105] openocd.cfg confusion**
**Status:** new
**Milestone:** 0.9.0
**Created:** Fri Aug 21, 2015 12:51 PM UTC by PEdro
**Last Updated:** Fri Aug 21, 2015 12:51 PM UTC
**Owner:** nobody
Hi everyone , i am really sorry to post this here , but it looks that in forum
of openocd i have to wait from administration approoval .
This is the first time i am using openocd , and i know that i need to configure
an openocd.cfg file to avoid this message :
Open On-Chip Debugger 0.10.0-dev-00022-g2dcf7bf-dirty (2015-08-15-20:27)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
embedded:startup.tcl:60: Error: Can't find openocd.cfg
in procedure 'script'
at file "embedded:startup.tcl", line 60
Error: Debug Adapter has to be specified, see "interface" command
embedded:startup.tcl:60: Error:
in procedure 'script'
at file "embedded:startup.tcl", line 60
But i didnt not found yet on the net or even on openocd help , where is the
place i should put that file!!!!
I tryed on the root of the program , on the src folder , and still have this
error .
I am on linux and i am using an :
Bus 003 Device 002: ID 0403:6010 Future Technology Devices International, Ltd
FT2232C Dual USB-UART/FIFO IC
Could some gentle soul here give me an help on this ?
There is much lack of configuration setup information on the help about this
issue .
And if we go on the net , then we will find websites pointing configurations to
old drivers that are not already in openocd .
As last resort , i try this site to try to fix this issue , but as always ,
they did not explain where to put that config file .
http://www.fun-tech.se/stm32/OpenOCD/index.php
Again , sorry for posting this here , i know that for some of you should be a
piece of cake , but for me is a dead end .
Thank you for your understanding .
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.------------------------------------------------------------------------------
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
