---
** [tickets:#205] Olimex ARM-USB-OCD-H Debugger PXA Programming Issue**
**Status:** new
**Milestone:** 0.9.0
**Created:** Wed Aug 22, 2018 04:15 AM UTC by Madhusudhan H Krishnasetty
**Last Updated:** Wed Aug 22, 2018 04:15 AM UTC
**Owner:** OpenOCD-Gerrit
**Attachments:**
-
[pxa_olimex.jpg](https://sourceforge.net/p/openocd/tickets/205/attachment/pxa_olimex.jpg)
(99.4 kB; image/jpeg)
Dear All,
I am very new to the family of open On-chip debugger. I need your help and
support to use OCD products which are required for my project.
I would like to explain about the openocd debugger or programmer I am using in
our project and need your valueable inputs.
* I am using Amontec JTAGkey2 programmer to program PXA and CPLD. It is working
absolutely fine without any issues.
* Since I am having only one Amontec device and there is no support available,
I found Olimex ARM-USB-OCD-H as an alternative device and started working on it.
* I verified pin confifuration between the two devices are almost the same
except pin2 in Olimex device has Vref.
* Issues I am facing with Olimex programmer:
1. When I execute the command: **openocd.exe -f pxa.cfg** following
warning and error I'm getting
* Warn : Bad value '00' captured during DR or IR scan:
Warn : check_value: 0x02
Warn : check_mask: 0x07
Error: JTAG error while writing DCSR
2. Next step is to telnet to the localhost 3333 and then typed the command
: **flash write_image erase unlock c:/pxa.nb0 **, for PXA porgramming.
* I am unable to flash PXA programming and the error message I am
getting is: Failed to receiving data
from debug handler after 1000 attempts
Execution of flash algorythm failed. Can't fall back. Please report.
error writing to flash at address 0x00000000 at offset 0x00000000
I have attached the sceenshots for the reference.
Using Amontec device PXA programming and CPLD programming writing smoothly
without any issues.
But why I am facing issues using Olimex ARM-USB-OCD-H programmer. Your kind
support is much appreciated.
Thanks and regards,
Madhusdhan H K
---
Sent from sourceforge.net because openocd-devel@lists.sourceforge.net is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
OpenOCD-devel mailing list
OpenOCD-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/openocd-devel
