Hi Tom,
I've tested your latest commit and all is working now. Thank you for the quick
turnaround. I've pasted the output of a flash write transaction below for your
reference.
Best Regards,
Michael Wolak
Michaels-MBP-2:~ michaelwolak$ telnet localhost 4444
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
Open On-Chip Debugger
> reset halt
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0x00001740 msp: 0x200082b0
> flash write_bank 0 /Users/michaelwolak/SAME_CLOCKS_SPI_120/gcc/AtmelStart.bin > 0
wrote 6372 bytes from file
/Users/michaelwolak/SAME_CLOCKS_SPI_120/gcc/AtmelStart.bin to flash bank 0 at
offset 0x00000000 in 0.429085s (14.502 KiB/s)
>
>
---
** [tickets:#288] DID 61810006 (Microchip ATSAME51G18A) Not supported**
**Status:** new
**Milestone:** 0.11.0
**Labels:** AT91SAME51
**Created:** Mon Dec 21, 2020 11:34 PM UTC by Michael Wolak
**Last Updated:** Tue Dec 22, 2020 08:29 AM UTC
**Owner:** nobody
After building 0.11.0-rc1+dev-00001-g0dd3b7fa6-dirty (2020-12-21-17:08) I was
not able to program the flash on a Microchip ATSAME51G18A-MF.
Here's a log of the operation I was running:
Connected to localhost.
Escape character is '^]'.
Open On-Chip Debugger
> flash write_bank 0
> /Users/michaelwolak/SAME_CLOCKS_SPI_120/gcc/AtmelStart.bin 0
Couldn't find part corresponding to DID 61810006
auto_probe failed
Thanks,
Mike
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
