On Mon, Oct 18, 2010 at 8:29 PM, Bernard Mentink <bernard.ment...@trimble.co.nz> wrote: > Hi Øyvind, > > So you achieved 100kbytes/sec on an LPC1778 ... Wow, > can you share your config file?
It's the board/mbc1700.cfg that is in origin/master. > Did you use the ZY1000 for > this test. I am using just a Cheap FT2232D based JTAG device ... > Is it the hardware that is the limitation here, or the software? If someone steps up and puts in an effort to optimize this for long latency devices, perhaps it could improve. Short latency is better than long latency though... > Regarding flashing, I am using the " mon flash write_image erase unlock > file.elf 0 elf" > command from GDB, I don't know if that is executing on the target.. Try just "load" from GDB. -- Øyvind Harboe US toll free 1-866-980-3434 / International +47 51 63 25 00 http://www.zylin.com/zy1000.html ARM7 ARM9 ARM11 XScale Cortex JTAG debugger and flash programmer _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
