On Nov 2, 2010, at 6:25 PM, Mr Dash Four wrote: > Two general questions: > > 1) To retrieve a data object (previously stored with "pkcs15-init -P" > etc) I use "pkcs11-tool -ry data --application-label XXX --slot YYY" (if > this data object is public, if private I add the -l option as well) > where YYY and XXX are specified/known in advance. Is this going to work > on all cards supported by OpenCT; and Please don't mix OpenCT (about accessing card terminals or readers/tokens) and OpenSC (about talking to cards via whatever supported interface).
pkcs11-tool with data objects should work with all cards that have data objects support in their profile, and also other PKCS#11 providers. > 2) Is the method of retrieval of data on this object the same regardless > of the card used (i.e. executing pkcs11-tool with the above parameters > and then either no PIN prompt if the object is public or a PIN prompt if > the object has been stored with its --auth-id set)? Yes, this is how it should be. > The reason I ask this is because I would like the module I am developing > to work on (at least the majority of) cards which are (at least) > supported on OpenCT. What is the module you are writing? An alternative to OpenSC (not OpenCT) PKCS#11 module? (I'm going through a huge backlog of e-mails after being finally almost-OK from an unexpected swim session in an ice-cold lake when fishing ...) Cheers, -- @MartinPaljak.net +3725156495 _______________________________________________ opensc-devel mailing list opensc-devel@lists.opensc-project.org http://www.opensc-project.org/mailman/listinfo/opensc-devel