Hi,
I have one basic question, what is this tunneled over to network node means ?
(" At this point, the packet will go back out to br-int and but tunneled over
to the network node just like any other intra-network traffic.")
What kind of tunnel between Compute to Network Node during SNAT ?
Why tunneling will happen during NAT ?
Thanks & regards,
Keshava.A
-----Original Message-----
From: Carl Baldwin [mailto:c...@ecbaldwin.net]
Sent: Thursday, May 22, 2014 3:27 PM
To: OpenStack Development Mailing List (not for usage questions)
Subject: Re: [openstack-dev] [Neutron] Default routes to SNAT gateway in DVR
Hi,
I found this message in my backlog from when I was at the summit.
Sorry for the delay in responding.
The "default SNAT" or "dynamic SNAT" use case is one of the last details being
worked in the DVR subteam. That may be why you do not see any code around this
in the patches that have been submitted.
Outbound traffic that will use this SNAT address will first enter the IR on the
compute host. In the IR, it will not match against any of the static SNAT
addresses for floating IPs. At that point the packet will be redirected to
another port belonging to the central component of the DVR. This port has an
IP address different from the default gateway address (e.g. 192.168.1.2
instead of 192.168.1.1). At this point, the packet will go back out to br-int
and but tunneled over to the network node just like any other intra-network
traffic.
Once the packet hits the central component of the DVR on the network node it
will be processed very much like default SNAT traffic is processed in the
current Neutron implementation. Another "interconnect subnet" should not be
needed here and would be overkill.
I hope this helps. Let me know if you have any questions.
Carl
On Fri, May 16, 2014 at 1:57 AM, Wuhongning <wuhongn...@huawei.com> wrote:
> Hi DVRers,
>
> I didn't see any detail documents or source code on how to deal with
> routing packet from DVR node to SNAT gw node. If the routing table see
> a outside ip, it should be matched with a default route, so for the
> next hop, which interface will it select?
>
> Maybe another standalone "interconnect subnet" per DVR is needed,
> which connect each DVR node and optionally, the SNAT gw node. For
> packets from dvr
> node->snat node, the interconnect subnet act as the "default route"
> node->for this
> host, and the next hop will be the snat node.
>
> _______________________________________________
> OpenStack-dev mailing list
> OpenStack-dev@lists.openstack.org
> http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
>
_______________________________________________
OpenStack-dev mailing list
OpenStack-dev@lists.openstack.org
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
_______________________________________________
OpenStack-dev mailing list
OpenStack-dev@lists.openstack.org
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
