On Jun 28, 2016, at 11:36 PM, Remo Mattei wrote: > is this a multi deployment air?
"multi deployment air"? > Did you check if you can ping each other if in a multi? "in a multi"? If you mean, can I ping the Controller via eth0 and vise versa, without the traffic going through eth1, then yes: bladeA03b:~# ping -c2 10.99.0.1 PING 10.99.0.1 (10.99.0.1) 56(84) bytes of data. 64 bytes from 10.99.0.1: icmp_seq=1 ttl=64 time=1.19 ms 64 bytes from 10.99.0.1: icmp_seq=2 ttl=64 time=0.357 ms --- 10.99.0.1 ping statistics --- 2 packets transmitted, 2 received, 0% packet loss, time 1001ms rtt min/avg/max/mdev = 0.357/0.774/1.191/0.417 ms bladeA03b:~# traceroute -n 10.99.0.1 traceroute to 10.99.0.1 (10.99.0.1), 30 hops max, 60 byte packets 1 10.99.0.1 1.044 ms 1.040 ms 1.024 ms In this case, I'm pinging Controller/eth0 from the Compute (connected to the same Cisco switch, no VLAN tagging). > What does the ovs-vsctl show output is? bladeA03b:~# ovs-vsctl show 5e1ec384-b926-4148-9bfd-cbf7db56cfa2 Bridge br-physical Port "eth1" Interface "eth1" Port br-physical Interface br-physical type: internal Bridge br-tun fail_mode: secure Port patch-int Interface patch-int type: patch options: {peer=patch-tun} Port br-tun Interface br-tun type: internal Bridge br-provider fail_mode: secure Port "qvo6a866c7f-2b" tag: 1 Interface "qvo6a866c7f-2b" Port patch-tun Interface patch-tun type: patch options: {peer=patch-int} Port br-provider Interface br-provider type: internal Port phy-br-provider Interface phy-br-provider type: patch options: {peer=int-br-provider} Port "eth0" Interface "eth0" Port int-br-provider Interface int-br-provider type: patch options: {peer=phy-br-provider} Port "qvob15ee1e9-8a" tag: 1 Interface "qvob15ee1e9-8a" ovs_version: "2.3.0" > The UI/Dashboard sometimes show it’s down but it really > it’s not and it works fine. Ok, good. That's what it seems like here. Except the "external" port (the one on the "physical" network). However, looking at the router interfaces (screen shot included), all it's ports are "Down" :(. > It’s a bad case where this is a very common issue when > people are looking at the UI and that state is marked as > down and it works! > > Eventually it will show active. Perfect, thanx! -- You know, boys, a nuclear reactor is a lot like a woman. You just have to read the manual and press the right buttons - Homer Simpson
_______________________________________________ Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack Post to : openstack@lists.openstack.org Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack