Is there any instrucution I could follow to compile the kernel or build a image for panda board B3
2014-02-21 5:36 GMT+08:00 Nishanth Menon <[email protected]>: > On 02/20/2014 07:19 AM, 孙钰 wrote: >> The Uboot in Factory (u-boot 2014.01) works for RevB3, >> But the kernal fails.... >> >> Here follows the message: >> U-Boot SPL 2014.01 (Feb 05 2014 - 15:07:29) >> OMAP4460 ES1.1 >> >> >> U-Boot 2014.01 (Feb 05 2014 - 15:07:29) >> >> CPU : OMAP4460 ES1.1 >> Board: OMAP4 Panda >> I2C: ready >> DRAM: 1 GiB >> MMC: OMAP SD/MMC: 0 >> Using default environment >> >> Net: No ethernet found. >> Hit any key to stop autoboot: 0 >> mmc0 is current device >> SD/MMC found on device 0 >> 2113 bytes read in 3 ms (687.5 KiB/s) >> Running bootscript from mmc0 ... >> ## Executing script at 82000000 >> mmc0 is current device >> 4690280 bytes read in 215 ms (20.8 MiB/s) >> 68363617 bytes read in 3077 ms (21.2 MiB/s) >> 23288 bytes read in 8 ms (2.8 MiB/s) >> Kernel image @ 0x80000000 [ 0x000000 - 0x479168 ] >> ## Loading init Ramdisk from Legacy Image at 82000000 ... >> Image Name: Initrd >> Image Type: ARM Linux RAMDisk Image (uncompressed) >> Data Size: 68363553 Bytes = 65.2 MiB >> Load Address: 00000000 >> Entry Point: 00000000 >> Verifying Checksum ... OK >> ## Flattened Device Tree blob at 80f80000 >> Booting using the fdt blob at 0x80f80000 >> Using Device Tree in place at 80f80000, end 80f88af7 >> >> Starting kernel ... > > on my non B3 board: > http://slexy.org/view/s2YhugU4oW (3.13) > http://slexy.org/view/s2mU9djKVq (3.14-rc3) > > Looking at the dts, I guessed there are cs1 is being attempted, could > someone with a B3 board try http://slexy.org/raw/s20dkh58XR out (not > an official patch, just to get an idea). I am trying to get my hands > to a B3 board to verify as well, but might take a few days. > > > -- > Regards, > Nishanth Menon -- 孙钰 Address:北航新主楼F1015 -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
