On Monday 17 December 2007, Joe Sloan wrote: > Matt T. wrote: > > This is a while ago and it just worked, thus I did not take any notes... > > but ok, I try: > > > > Assuming you run 10.3 with a recent kernel. I don't remember if it was > > already working with the kernel and rt2x00-kmp out of the box, mainly > > because when I installed it I had already updated the kernel several > > times. > > > > - Install the rt2x00 module for your kernel; probably a reboot is helpful > > after that > > > > - do not load ndiswrapper, unload it if needed, and make sure it does not > > get loaded when rebooting. This might not matter as long as you have no > > win drivers for the DWL-G122 installed, but better be sure, and you won't > > need them anyway. > > > > - plug in the DWL-G122 - knetworkmanager will open a window and ask for > > connection details > > > > Note: IIRC I did not setup the card directly with Yast. It is managed > > through knetworkmanager / networkmanager > > Sounds right, except for the reboot - doh! no windoze involved, so we > just need a modprobe, not a reboot. > > Joe
Well, Joe, actually, this "probably helpful reboot" was mentioned because there could have been some windoze involved - if ndiswrapper was used and a windoze driver was loaded ... better reboot to get all relicts of evil out of memory ;) -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]