On 09:46 AM 5/09/2001 +0000, [EMAIL PROTECTED] said:
>I'm new in Protel. I've finished the schematic part of the design. I've
>created a pcb document using wizard and defined all the footprints. After
>that I've placed the components in the board. Now what I want is to create
>a single layer board. But when i autoroute all, it uses top and bottom layers.
>How can i prove that the tracks are on bottom and components are on top?
>Please answer to [EMAIL PROTECTED]
>
>Posted from Association web site by: seyyah
As Abdulrahman wrote, your question would be better placed on the Protel
EDA forum rather than the Off Topic forum, and the autorouter has been
shown to be not good for single layer jobs. Give it a try though..
Using Design Rules in the PCB editor you can set the routing layers (look
for the Routing Layers rule on the Routing tab). Set Bottom layer to "Any"
and all other layers to "Not Used".
Ian Wilson
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
