Hi to all the ole' regulars to the Techserve forums.
Well after a much too long forced hiatus I am coming back. Next week
I will be starting a new job using Protel again. After I get settled in I
will rejoin the forum and take up providing assistance to those with
problems I have faced or know the answers and methodology to work around.
In the meantime I have been briefly employed using PADs, yuck! Even
though I had formerly used and liked PADs, I cannot believe that they have
done so little development in the past 5 - 6 years. It is a clunky dinosaur
compared to Protel. I look forward to going back to Protel, even with all of
it's headaches and longstanding bugs.
To any of the ole' gang, give me a reply just so that I know who is
still around and who has migrated completely to the Protel DXP forum. At my
new position I will still be using P99SE for some very specific reasons,
don't see any migration to DXP or 2004 for the near future.
Sincerely,
Brad Velander
PCB Designer
Xantrex Technology Inc.
(direct) (604) 415-4054
(general) (604) 422-8595 ext. 4054
(fax) (604) 422-1591
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
