Hello, I googeled my question, but unfortunately, I could not find a correct and complete article about it and I'm thankful if the experts here, write the answer step by step and in summary.
Suppose you have an OpenVPN server. Now, you want to set two public IP addresses on it. Your public IP addresses are: 1.2.3.4 1.2.3.5 Your OpenVPN server has one NIC as below: # ifconfig enp0s3: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 10.0.2.15 netmask 255.255.255.0 broadcast 10.0.2.255 inet6 fe80::a00:27ff:feed:b47c prefixlen 64 scopeid 0x20<link> ether 08:00:27:ed:b4:7c txqueuelen 1000 (Ethernet) RX packets 14915 bytes 2455731 (2.3 MiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 11701 bytes 1581492 (1.5 MiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10<host> loop txqueuelen 1000 (Local Loopback) RX packets 4 bytes 336 (336.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 4 bytes 336 (336.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 Can you show how to prepare your OpenVPN server step by step? For example, You must first create a virtual network card and assign the IP addresses to it then… The goal of this project is that you want different users to connect to different IP addresses. I’m sure this thread is very useful for many users. Thank you. _______________________________________________ Openvpn-users mailing list Openvpn-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/openvpn-users