#17839: Reboot command causes sometimes hanging router with TL-WDR3600 (HW V1.5)
and TL-WDR4300 (HW V1.7)
--------------------------+-----------------------------------
Reporter: michaeluray | Owner: developers
Type: defect | Status: new
Priority: high | Milestone: Barrier Breaker 14.07
Component: base system | Version: Barrier Breaker 14.07
Resolution: | Keywords: reboot
--------------------------+-----------------------------------
Comment (by balazs.pomykala):
This week I bought a brand new TP-Link WDR-4300 router, hardware rev. 1.7.
I tested the original firmware for a couple of days - TL-
WDR4300_V1_130617-. I did not have any problem with it.
After it I flashed BB-RC3 - openwrt-ar71xx-generic-tl-wdr4300-v1-squashfs-
factory.bin from
http://downloads.openwrt.org/barrier_breaker/14.07-rc3/ar71xx/generic
/openwrt-ar71xx-generic-tl-wdr4300-v1-squashfs-factory.bin- and noticed
that most of the cases when I issue a reboot from ssh terminal. It can
not restart. When I apply a power off-on power cycle, it can start every-
time.
First I thought there is some problem with the installed packages.
Therefore I erase rootfs_data with fail safe -
http://wiki.openwrt.org/doc/howto/generic.failsafe -.
But still the same problem exist even thought I did not installed any
package.
I performed a couple of reboot tests and most of time it cannot restart.
When I issue a reboot from terminal I can see that all leds goes down -
only power is on-. But the router did not reach that state of the boot
process that sys led starts to blink.
--
Ticket URL: <https://dev.openwrt.org/ticket/17839#comment:6>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets
