From: Adrian Farrel <adr...@olddog.co.uk> Sent: 28 May 2020 14:29 Hey Tom,
Is there a typo in your email? You said... > So carving out the current types (etc) will likely lead to a bad > outcome; it is a question of looking carefully across the range > of documents to see what is, or is likely to be common. I wondered whether you intended a "not" in there somewhere. <tp> Adrian, no, no 'not' was intended. The danger is taking e.g. the 50 or so pages of identity, typedef, grouping in L2NM and assuming that they form a good starting point or, worse still, making a logical OR of the four documents under consideration and to create a monster document and assuming that that is a good basis. Critical assessment is what is needed IMHO. Sometimes it is better to create your own version of vpn-id or ODUC than import a hundred pages of someone else's in order to get them. Tom Petch If you wrote what you intended, could you explain a little further what the danger is? Best, Adrian -----Original Message----- From: OPSAWG <opsawg-boun...@ietf.org> On Behalf Of tom petch Sent: 26 May 2020 17:05 To: Joe Clarke (jclarke) <jclarke=40cisco....@dmarc.ietf.org>; Oscar González de Dios <oscar.gonzalezded...@telefonica.com> Cc: opsawg <opsawg@ietf.org> Subject: Re: [OPSAWG] Minutes of L3NM/L2NM module discussions From: OPSAWG <opsawg-boun...@ietf.org> on behalf of Joe Clarke (jclarke) <jclarke=40cisco....@dmarc.ietf.org> Sent: 21 May 2020 15:43 2. L3NM Revision of the three main issues: Implementation Report by Cisco. It has two main issues (https://github.com/IETF-OPSAWG-WG/l3nm/issues/110) - Common module to have all the L3NM specific requirements. Type-like module. [Anton]: It makes implementation simpler. Does not generate unnecessary dependencies [Adrian]: It depends on if we need module for specific types, to avoid unnecessary imports. Also don't you only need to import types, not the entire module? [Qin]: With L3SM we did not take an augmentation approach. If there are common types defined in both models, then we may need to find the common components. We should decouple of L3SM. [Sriram]: Prefer to have a separate type-file for the specific parameters. [Oscar]: Define a common type-file for the service models. [Qin]: Is it possible to manage it as an independent draft? [Oscar in github issues]: After the discussions, it seems reasonable to have a separate Yang module to contain the types. The suggestion is to write the module to cover the four service models (client service models, l3sm, l2sm and Network service models, l2nm, l3nm). It seems reasonable to include this module in l3nm draft instead of creating a new one to avoid dependencies. Samier, Dan and Anton to collaborate for a first version of the split As chair, I want to call this out since it sounds like the authors made a decision here, and I want to make sure the whole WG has a chance to weigh in. In reading these minutes and issue #110, I can see the value of a types module to avoid what may be confusing imports, but I want to know if anyone on the WG has a different opinion. <tp> Joe The four documents are not spelled out but referred to in shorthand and while I think I know which are intended, that IMHO needs spelling out. In principle, a common types is a no-brainer provided it is done early enough - before anything becomes an RFC! - and with limited enough scope. NETMOD got it right but did have decades of SMI experience to go on, RTGWG got it right, with TEAS it is less clear while layer0-types has changed much over its short life - is it right now? May be. So carving out the current types (etc) will likely lead to a bad outcome; it is a question of looking carefully across the range of documents to see what is, or is likely to be common. The higher up the stack you go the more likely items are to be common but equally the more likely it is that someone has been there already. And if you look at existing types modules, it took a while for the penny to drop but they end up as separate I-D, better still with a different author to the importing I-D; a no brainer really. Tom Petch Joe _______________________________________________ OPSAWG mailing list OPSAWG@ietf.org https://www.ietf.org/mailman/listinfo/opsawg _______________________________________________ OPSAWG mailing list OPSAWG@ietf.org https://www.ietf.org/mailman/listinfo/opsawg