Hi,
I have set up a slave node at a remote site and followed the docs for
building this and pushing the install onto the slave.
Everything went OK and I configured several hosts to be monitored from
the slave.
However, once the checks run after configuring a host, they immediately
change state to: UNKNOWN: Service results are stale
The Slave-node check on the master is reporting as OK. If I shut down
Opsview on the slave I get a Slave-node notification as expected.
send2slaves -t reports success.
The web interface on the slave is reporting everything as OK, all green
and seemingly fine but I cannot get the master to sync and report as OK.
After I generated some alerts (shut some monitored services down, etc)
the slave seems to have gone a bit crazy and is pumping out tens of
mails every few seconds even though the alerts are OK again.
I had to shut down the MTA, and then Opsview on the slave as it was
getting into the thousands of alerts. If I start the slave again it
continues.
Opsview version: 3.1.0.2553 (Im going to upgrade after my migration =)
Any ideas what I should be looking for to get the master to report as OK
and how to stop the copious amounts of alerts from the slave?
Thanks.
Regards,
Andy.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
Opsview-users mailing list
[email protected]
http://lists.opsview.org/lists/listinfo/opsview-users
