Hi everyone,
Is there a fix for this? I just upgraded both my master and slave from
3.1 to 3.5 and am now getting this error. I am able to push new configs
to the slave and my slave is reporting everything is fine but the status
is not being sent to the master.
Any help on this would be appreciated.
Thanks
Joe
Andy Ashley wrote:
Hi,
I have set up a slave node at a remote site and followed the docs for
building this and pushing the install onto the slave.
Everything went OK and I configured several hosts to be monitored from
the slave.
However, once the checks run after configuring a host, they
immediately change state to: UNKNOWN: Service results are stale
The Slave-node check on the master is reporting as OK. If I shut down
Opsview on the slave I get a Slave-node notification as expected.
send2slaves -t reports success.
The web interface on the slave is reporting everything as OK, all
green and seemingly fine but I cannot get the master to sync and
report as OK.
After I generated some alerts (shut some monitored services down, etc)
the slave seems to have gone a bit crazy and is pumping out tens of
mails every few seconds even though the alerts are OK again.
I had to shut down the MTA, and then Opsview on the slave as it was
getting into the thousands of alerts. If I start the slave again it
continues.
Opsview version: 3.1.0.2553 (Im going to upgrade after my migration =)
Any ideas what I should be looking for to get the master to report as
OK and how to stop the copious amounts of alerts from the slave?
Thanks.
Regards,
Andy.
_______________________________________________
Opsview-users mailing list
[email protected]
http://lists.opsview.org/lists/listinfo/opsview-users
