Hi,
I did following configuration; but did not see .ndo_setup_tc() of my driver
getting called. Any clue/hint. I did below based on
https://www.youtube.com/watch?v=15jgDWvH1Uo .
Thanks,
Ratheesh
ethtool -K eth0 ntuple off
ethtool -K eth0 hw-tc-offload on
ethtool -K sdp1-0 ntuple off
ethtool -K sdp1-0 hw-tc-offload on
ovs-vsctl set Open_vSwitch . other_config:tc-policy=skip_sw
ovs-vsctl set Open_vSwitch . other_config:hw-offload=true
root@localhost:~/essential# ovs-vsctl show
90a6bd0c-f371-4471-8779-a33f91cff039
Bridge "br0"
Port "sdp1-0"
Interface "sdp1-0"
Port "br0"
Interface "br0"
type: internal
Port "eth0"
Interface "eth0"
ovs_version: "2.5.9"
I could see that ping is successful.
root@localhost:~/essential# ovs-ofctl dump-flows br0
NXST_FLOW reply (xid=0x4):
cookie=0x0, duration=16.908s, table=0, n_packets=14, n_bytes=1334, idle_age=1,
in_port=1 actions=output:2
cookie=0x0, duration=12.672s, table=0, n_packets=14, n_bytes=1334, idle_age=1,
in_port=2 actions=output:1
_______________________________________________
discuss mailing list
[email protected]
https://mail.openvswitch.org/mailman/listinfo/ovs-discuss
