Update: I just upgraded to 2.8p6, but I don't see much difference :( On Feb 7, Markus Gaugusch <[email protected]> wrote:
> Hi! > > In a posting from late 2009 [1], someone managed to use the alarm mode of > a DS2406 (but not DS2408). > > My Question: How does it work on the DS2406, and has it been fixed for the > DS2408? > > I tried it on a DS2406, channel B, wich is currently showing "1" for > sensed: > echo 230 > set_alarm > Now I do "ls" in /mnt/1wire/bus.0/alarm and find several nodes (all of my > ds18s20 temperature sensors and 2-3 of my three ds2406). This is too much! > > I haven't even yet changed the sensor input, but after changing the sensed > value to 0, there is no change either. > > I use a ds2480B serial interface (via USB RS232 adaptor) and owfs 2.7p13. > > Thank you in advance for your reply! > > best regards, > Markus > > > [1]: > http://www.mail-archive.com/[email protected]/msg06574.html > > -- __________________ /"\ Markus Gaugusch \ / ASCII Ribbon Campaign markus(at)gaugusch.at X Against HTML Mail / \ ------------------------------------------------------------------------------ The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: Pinpoint memory and threading errors before they happen. Find and fix more than 250 security defects in the development cycle. Locate bottlenecks in serial and parallel code that limit performance. http://p.sf.net/sfu/intel-dev2devfeb _______________________________________________ Owfs-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/owfs-developers
