It wouldn't matter if salt water destroyed a moisture sensor. I would take
occasional readings of the 7 compartments. Any reading other than
"completely dry" would mean I would have to cut an inspection hole in that
compartment and address the problem.
Thanks again,
Peter
On Sun, Jul 7, 2013 at 8:37 AM, Jan Kandziora <[email protected]> wrote:
> Am 07.07.2013 17:24, schrieb Peter Hollenbeck:
> > Could I use leaf wetness sensors such as this:
> > http://www.hobby-boards.com/store/products/Leaf-Wetness-Sensor.html
> >
> Should work for a while, at least as long the bilge is dry. Once
> seawater gets in contact with the board I think it has to be replaced
> because of the salty dirt stain is hard to remove.
>
> Kind regards
>
> Jan
>
>
>
>
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by Windows:
>
> Build for Windows Store.
>
> http://p.sf.net/sfu/windows-dev2dev
> _______________________________________________
> Owfs-developers mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/owfs-developers
>
------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:
Build for Windows Store.
http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
Owfs-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/owfs-developers
