Gerald, Since you compiled from source, can you do debug build and then run through a debugger to see why it's aborting? I don't think I've seen this behaviour before. I wonder if its related to the dependency issue. Was this a clean build or were you doing an incremental build?
Utkarsh On Wed, Dec 18, 2013 at 9:19 AM, Lodron, Gerald <gerald.lod...@joanneum.at> wrote: > Hi > > > > I successfully compiled paraview 4.1.0 with python 2.7.3 enabled in 32 bit. > Paraview also starts but when I generate ANY data (over open file or over > sources->Sphere or box or anything else etc.) it closes after pressing > Apply. Does anyone has a clue what could cause that strange behaviour? > > > > Thanks for advice….. > > > > Best regards > > Gerald Lodron > > > > _________________________________________________________________ > > > > JOANNEUM RESEARCH Forschungsgesellschaft mbH > > > > DIGITAL – Institute for Information and Communication Technologies > > Steyrergasse 17, 8010 Graz, Austria > > > > phone: +43 316 876-1751 > > fax: +43 316 8769-1751 > > e-mail: gerald.lod...@joanneum.at > > web: www.joanneum.at/digital > > _________________________________________________________________ > > > > This message and any attached files are confidential and intended solely for > the addressee(s). Any publication, transmission or other use of the > information by a person or entity other than the intended addressee(s) is > prohibited. If you receive this in error please contact the sender and > delete the material. The sender does not accept liability for any errors or > omissions as a result of the transmission. > > > > Please consider the environment before printing this page. > > > > > > > _______________________________________________ > Paraview-developers mailing list > paraview-develop...@paraview.org > http://public.kitware.com/mailman/listinfo/paraview-developers > _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
