In a message David Elmo <[EMAIL PROTECTED]> writes:

<< In-Reply-To: <[EMAIL PROTECTED]>

> Subject: [PCI] Number of starts for my 7600 today...
> From: David Elmo <[EMAIL PROTECTED]>

> Took 12 starts and restarts to get my 7600 fully booted today. It is so
> fascinating ... and it rocks and is a rock for the rest of the day...
> Yesterday, a miracle and only 3 starts... Average is 4 for last month.
> 
> David Elmo

Today, 15 starts. But Gauge Pro in a spare moment when I have a break, has 
come up with a memory error, which might explain all this nonsense that has 
been 
going on for so long. "Memory Error at address $01FF4AB4 but read $05FF4AB4" 
I don't suppose anyone can say how i can usefully use this notice to pinpoint 
the chip concerned? If the following gets all unwrapped, I am sorry.

Memory overview
Disk cache:    8160K
Virtual memory:    is off
Built-in memory:    832 MB

Location        Size    Memory type
    B4                    128 MB            DIMM
    A4                    64 MB            DIMM
    B3                    64 MB            DIMM
    A3                    64 MB            DIMM
    B2                    128 MB            DIM
    A2                    128 MB            DIMM
    B1                    128 MB            DIMM
    A1                    128 MB            DIMM
External L2 cache:    Not installed>>

----------------------------------------
My reply:

There has been an incredibly good discussion on the G-list last week 
concerning the testing of DIMMs with Gauge Pro.

See these links to G-List archives -- be warned these are very long posts.

<http://www.mail-archive.com/g-list%40mail.maclaunch.com/msg38676.html>
<http://www.mail-archive.com/g-list%40mail.maclaunch.com/msg38739.html>

>From these post it is believed the RAM used at startup is either the first 
slot, the last slot or possibly both. This theory predates the release of G3's 
and should apply to PCI Macs. The G's have only one bank of RAM and most of our 
beloved PCI Mac have two.

So . . . assuming this premise if correct; I would remove the DIMMs in A1, 
B1, A4, B4 and run Gauge Pro again. If 7600 starts up OK and Gauge Pro comes up 
negative you have isolated the bad DIMM to 4 chips. From there you can use the 
"sandwich" method as described in the links above to find the defective chip.

This all assumes (2nd assumption) that your startup problem is a result of 
defective RAM.

HTH --glen



 

-- 
PCI-PowerMacs is sponsored by <http://lowendmac.com/> and...

 Small Dog Electronics    http://www.smalldog.com  | Refurbished Drives |
 -- Sonnet & PowerLogix Upgrades - start at $169   |  & CDRWs on Sale!  |

      Support Low End Mac <http://lowendmac.com/lists/support.html>

PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml>
  --> AOL users, remove "mailto:";
Send list messages to:   <mailto:[email protected]>
To unsubscribe, email:   <mailto:[EMAIL PROTECTED]>
For digest mode, email:  <mailto:[EMAIL PROTECTED]>
Subscription questions:  <mailto:[EMAIL PROTECTED]>
Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/>

iPod Accessories for Less
at 1-800-iPOD.COM
Fast Delivery, Low Price, Good Deal
www.1800ipod.com

Reply via email to