A little hydrofluoric acid will remove everything from the sensor. The only problem with just blowing is that the removed particles are most likely to remain in the camera's light box accumulating to mount a second sensor invasion. Further, there are oils in the air which will eventually build up. Not only will the oils degrade the image, they will aid dust particle invasion by sticking them to the sensor. How soon this will happen is probably related to how much diesel traffic crop spraying goes on in your area. No amount of huffing and puffing will blow this down. I expect digital SLR CLA to be required more often than with film. There are several cleaning kits on the market specifically for sensors, but I've not tried them yet.
Advantage - Digital P&S and Film. Regards, Bob... -------------------------------------------------------- "Art is not a reflection of reality. it is the reality of a reflection." -Jean Luc Godard ----- Original Message ----- From: "MikeM" <[EMAIL PROTECTED]> > After changing lenses a few times in the last week, always as > carefully possible, pointing the K100 down, there were a few blobs > on the shot taken after one of the changes. I didn't have a sensor > cleaning kit so I used the blower from a cheap blower brush and it > did the trick. Did I get lucky? Does the coating I read about on the > Pentax sensors make it easier to blow dust off? I assume it won't > always be so easy to clean, so are there any suggestions a to which > cleaning kit to get? -- PDML Pentax-Discuss Mail List PDML@pdml.net http://pdml.net/mailman/listinfo/pdml_pdml.net to UNSUBSCRIBE from the PDML, please visit the link directly above and follow the directions.