From: "Patrick Genovese" <[EMAIL PROTECTED]> >Adjust noise amount to taste. . .
Patrick: Now the challenge ahead is for me to cultivate a sense of taste! ;-) Seriously, thanks. This advice should help. Cheers, Christine ----- Original Message ----- From: "Patrick Genovese" <[EMAIL PROTECTED]> To: "Pentax-Discuss Mail List" <pdml@pdml.net> Sent: Tuesday, February 26, 2008 1:49 AM Subject: Re: Advice for Applying Grain > This is the way I do in in PS. > > 1. Add a new layer and fill it with 50% gray (RGB 128,128,128) & Set > the layer blend mode to overlay > 2. Use Filter/Noise/Add Noise Tick Gaussian + Monochromatic. > 3. Adjust noise amount to taste I usually end up with anything between > 0.5% to 15%. This naturally depends on the image. > 4. Adjust the layer opacity to fine tune the effect. > > I Sometimes I apply a bit of unsharp mask to the noise layer but it > does not always give a pleasing result. > > Hope this helps > > Regards > > Patrick > > -- > PDML Pentax-Discuss Mail List > PDML@pdml.net > http://pdml.net/mailman/listinfo/pdml_pdml.net > to UNSUBSCRIBE from the PDML, please visit the link directly above and > follow the directions. > -- PDML Pentax-Discuss Mail List PDML@pdml.net http://pdml.net/mailman/listinfo/pdml_pdml.net to UNSUBSCRIBE from the PDML, please visit the link directly above and follow the directions.