Hi all
can someone please (re)explain to me about "Orcad Ports" in 99SE Tools Prefs
I have schematic design that came from DXP saved back to 99SE
a lot (but not all) of the ports were not attached to their wires
i made them bigger and smaller as needed and all was well
now some days later opening the file on another machine the ports are all mis-sized again, this time usually too long and overlapping the net label
i remembered this was maybe "Orcad Ports"
it was checked on this machine
i unchecked it, no change
saved files, restarted protel, no change
any clues why they jump around in size, aparently when working from different machines ?
Dennis Saputelli
_______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com
Andy Gulliver wrote:
In case anyone has the link rather than the file saved, the Design Guide is now at http://www.minco.com/uploadedFiles/Products/Flex_Circuits/aa24-flex_design.p df
Regards,
AndyG
-----Original Message----- From: Terry Creer [mailto:[EMAIL PROTECTED] Sent: 13 October 2004 06:12 To: 'Protel EDA Forum' Subject: Re: [PEDA] Flex do's and don'ts ?
Hi Dennis,
Typically we use 0.001" base material, 1oz Rolled Annealed copper with a
0.001" coverlay on all 'standard' build flexibles.
I find the Minco Flex Design Guide to be most helpful: http://www.minco.com/pdf/aa24.pdf
There's other good documents on their Support page, too: http://www.minco.com/support/
Cheers,
TC
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
