There is a utility on the web called BMP2PCB. It takes a BMP picture of your logo and converts it into a pcb file. Then cut and past the result into your pcb library and off you go Best Regards (Mr) Laurie Biddulph
--------------------------------------------------------------------------------
Elby Designs
9 Follan Close
Kariong
NSW 2250
Australia
Ph: +61 (0)2 4340 1525
Official supplier of the ASM-1 and ASM-2 Analogue Synthesiser PCBs
Software and hardware design for the Psion and Palm family of palmtop computers
Visit us at www.elby-designs.com
--------------------------------------------------------------------------------
This email (including any attachment) is confidential. If you are not the
intended recipient, you must not disclose or use this email or the information
contained
herein for any purpose. If you have received this email in error, please
immediately advise us by reply and delete this email. This email may not be
altered,
forwarded or re-issued without our consent.Elby Designs are not responsible for
any changes made to this email or the effect of any
changes on the email's meaning. It is the responsibility of the recipient to
scan this email for viruses and faults prior to processing.
Elby Designs shall not be liable for any loss or damage caused by this email
from transmission, viruses, faults or the use of data
accompanying this message. Elby Designs reserves all its rights, including
copyright,in this email.
----- Original Message -----
From: Paresh Pai
To: Protel forum
Sent: Tuesday, February 01, 2005 3:48 AM
Subject: [PEDA] reg bitmap
Dear All,
Can anybody tell me how to get a bitmap (say, a company logo) on the top or
bottom layer of a double sided PCB . I am using Protel 99 SE SP6.
Thanks in advance.
Paresh Pai
Goa India
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
<<Elby.jpg>>
____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
