I use PDF995 from/with 99SE and have no problems printing landscape from documents that have been produced in 99SE. I do notice however that the print setup->properties->Layout, "Advanced" button (in the PDF995 printer dialog) gives the option of having rotated pages ... which may undo the landscape option (although, just a guess). I always set the option in 99SE to "Scale to fit page, and I set the margins much smaller than 1" as well ...
As far as the document size is concerned, it is rather inconsequential once it is printed to PDF, as the Zoom facility in the Adobe reader lets you see it at any size you like Perhaps you should try A4. (Letter, if you are in the US). Alternatively, have you tried printing it in Portrait? Perhaps it will come out in Landscape? You don't say if you are trying to print this from DXP, or from 99SE. (Will 99SE load DXP schematics?) Cheers Harry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Jeff Condit Sent: Tuesday, April 19, 2005 7:19 AM To: Protel EDA Forum Subject: [PEDA] Landscape Printing to PDF995 The schematic DXP 2004 schematic I inherited is landscape tabloid (17" wide by 11" tall). It is defined as 1" less in each direction in the document options. No matter what combination of landscape/portrait I choose in either the printer setup or the print screen I cannot seem to get the landscape schematic to print on the landscape sheet. It always comes out a landscape image shrunk to fit across a portrait sheet. Any ideas? Jeff ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
