Hi Brad,
The initial reply went out to the discussion list. Even though I'm in the same state as their server, I note that it takes about 2 hours before I see my posts reflect back. I can exchange email with a client in Boston (3000miles away) almost instantaneously.
I too occasionally see a reply without seeing the original post. You may yet see the original post that I made at 4:39PDT yesterday. With their server - who knows?
Regards - Harry
At 01:57 PM 5/8/2005, you wrote:
Harry,snip
just wondering, did you reply directly to Soren the first time? I saw him reply to your response and I see your second response below but didn't get your initial reply. Seems the PEDA server is acting up and missing on the delivery of some messages.
Sincerely, Brad Velander Senior PCB Designer Northern Airborne Technology 1925 Kirschner Rd., Kelowna, BC, V1Y 4N7. tel (250) 763-2329 ext. 225 fax (250) 762-3374
-----Original Message----- From: Harry Selfridge [mailto:[EMAIL PROTECTED] Sent: May 8, 2005 10:06 AM To: Protel EDA Discussion List Subject: Re: [PEDA] PCB: Place from file?
Soren,
I assume you must be using Protel99SE, since DXP2004 has special utilities for doing multi-channel boards.
I just tried it and it works perfectly using Protel99SE. I saved a PIK file, moved a component off the board and rotated it, saved my modified board, then auto positioned using the PIK file I saved earlier. The component ended up back where it was before I made the changes.
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
