Then you can do layer specific keepouts.
Draw a regular line (not a track) on the layer you want the keepout on
(thickness/width doesn't matter). Then edit the line and change it to a keepout
by selecting the small checkbox at the bottom of the properties window for that
line. Unfortunately changing the keepout status is not a globally supported
option, so you must do it manually for each line you use.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Brad Kosiance [mailto:[EMAIL PROTECTED]
Sent: July 26, 2005 1:43 PM
To: [email protected]
Subject: [PEDA] Speaking of keepout layers ...
Since the keep out layer is not assigned to a specific copper layer what if
you want different keep out areas on the top layer and bottom layer?
Thanks,
Brad.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
