mirror will do that
the connector on the left will appear on the right
maybe i don't fully understand the issue you are raising ?
have you tried it ?
ds
_______________________________________________________________________
Integrated Controls, Inc. Tel: 415-647-0480 EXT 107
2851 21st Street Fax: 415-647-3003
San Francisco, CA 94110 www.integratedcontrolsinc.com
Brad Kosiance wrote:
That works for text but I also want the PCB view to be from the bottom side
(i.e. if there is a through hole connector located on the bottom left with a
top view I want it at the right for the bottom view).
I want to view the whole board and all components as if I am looking up from
the bottom (the top layer will now be the bottom layer).
Brad.
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Dennis Saputelli
Sent: August 26, 2005 3:17 PM
To: Protel EDA Discussion List
Subject: Re: [PEDA] Bottom View.
easy
just check 'mirror' in the PPC setup
you may want to put some strings backwards on some bottom assy mech
layers such as board number, "BOTTOM SIDE ASSY DWG" or 'SECONDARY SIDE'
or whatever
ds
_______________________________________________________________________
Integrated Controls, Inc. Tel: 415-647-0480 EXT 107
2851 21st Street Fax: 415-647-3003
San Francisco, CA 94110 www.integratedcontrolsinc.com
Brad Kosiance wrote:
What is the best way to create assembly diagrams for the bottom layer?
I would like to print out the component outlines and designators with a
bottom view not a BottomLayer view.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
