I am doing a large 4 layer board, and I am trying to follow the
instructions in the DE99 destruction manual.
It does not work as it says in the book, and as always, in a rush to do
the boards.........
I am doing this on an existing design, and just doing simple complete
re-designs, while I get constant updates and changes, the usual....
I have set up a GND and a +15V internal layer.
It will not let me pick a net for it on either plane.
If I add another plane, (5th layer) then it lets me add the net ot it.
I have 2 +5V nets, +/- 15V. 12V for the power plane nets, and a ground
and digital ground for the GND plane.
I can't set nets for either, but I can put in the polygons for the
grounds, and they are there, but not connected at connectors yet....
It does connect to the pads like it should, but still have to fake it
out at connector.......or do it right........
I have selected the power nets, the power layer was on, and in draft
mode for the pads.
It says I have no internal planes defined in the stack........
Do I have to remove everything on those layers first? Some tracks still
there, from last design.
Should I remove all the nets from the 2 inner layers and re-do it?
Is there a page missing from the destruction manual?
The forum is the only place I know that can help me out, and sure hope
that it won't go away..........
Thanks!
Leif Erickson
ELMOS North America.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
