Hi Guys,
Have I just been away from Protel layouts for too long or am I going
senile?
I have a mounting pad where I used a padstack to accommodate different
sized pads top and bottom. On the bottom I have a 218mil pad, on the top I have
a 318mil pad. The Gerbers come out just fine but my print preview prints have a
318mil pad printed on the bottom layer. I can't find the reasoning behind this.
It is essentially printing out a pad size on the bottom layer that is only
found on either the top of mid layers of the padstack. What am I forgetting
about?
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
