Hi Brad, I expect that it's the multilayer pad being printed and maybe the midlayer size is that size, try changing the midlayer size to 218mill ? Not sure what else it might be.
Regards, Darren Moore > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Brad Velander > > > Hi Guys, > Have I just been away from Protel layouts for too long > or am I going senile? > > I have a mounting pad where I used a padstack to > accommodate different sized pads top and bottom. On the > bottom I have a 218mil pad, on the top I have a 318mil pad. > The Gerbers come out just fine but my print preview prints > have a 318mil pad printed on the bottom layer. I can't find > the reasoning behind this. It is essentially printing out a > pad size on the bottom layer that is only found on either the > top of mid layers of the padstack. What am I forgetting about? > > Sincerely, > Brad Velander ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
