Yeah,
I know, I have read the same complaint a number of times both on this
forum and the DXP forum. However, across two companies and the last 6 years of
constantly using Protel P99SE, I haven't had it default to A4 size even once.
It either comes up on Letter or it may come up on 11 x 17/Tabloid if that was
what I last set it to for a similar print function.
My suggestion was not that it was just the driver, that would mean it
'should' also behave the same way with other apps but rather a combination of
the driver and something in Protel's code.
Over the whole time I have used Protel I have always been connected to HP laser
printers, 5000 or various 5 series printers.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: bob stephens [mailto:[EMAIL PROTECTED]
Sent: Wednesday, December 07, 2005 12:15 PM
To: 'Protel EDA Discussion List'
Subject: RE: [PEDA] Default paper size
Hmm... I don't think my particular problem is with the Windows Drivers. It
only happens in Protel. There has to be a global default setting somewhere,
but I have yet to find it. I set my templates up as "B" size explicitly and
whenever I turn my back the dammed Aussie POS defaults back to A4 or
something equally unpleasant.
:(
Bob
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
