Brad,
The best way to do it is to set those (or all) vias' properties
checkbox for a tented via. Found near the bottom of the via properties window.
Assuming P99SE, not sure about DXP or AD, etc..
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Brad Kosiance [mailto:[EMAIL PROTECTED]
Sent: Tuesday, January 17, 2006 10:28 AM
To: [email protected]
Subject: [PEDA] Solder Masks for vias.
For a via that is close to a surface mount pad I need the solder mask to
cover the via so that the via does not steal the solder away.
Is the best way to do this to set the Solder Mask Override setting to a
negative number (i.e. -20mil)?
99SE.
Thanks,
Brad.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
