Duane,
Best to do a quick check with your fabricator(s). Anyone here could say
yay or nay based upon what their fabricator can do and then you may end up
where your fabricator says they can't do it that way.
Your fabricator(s) should be your most valuable tool, your process
should use the best available tools.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Duane Foster [mailto:[EMAIL PROTECTED]
Sent: Thursday, January 19, 2006 11:24 AM
To: Protel EDA Discussion List
Subject: [PEDA] 16 layer question
I'm designing a 16 layer board and would like it to be 'vanilla' (easy to make
- low cost). Is .062" board thickness pretty standard fare for 16 layer?
thanks
Duane Foster
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
